Uppsetning á retract servói

[Sverrir]

Hérna er ágætis ráð um uppsetningu á retract servói.

[quote]Most retract servos should come with a large disc with pre-marked rings normally with the mm written on relating to the radius of each ring. What you need to do is measure the distance in mm that the actuating arm on the retract unit travels, then half it and that will give you the exact radius ring to fit you pushrod ball link to on the disc.
I.E. If your retract arm takes 24mm to move from fully down to fully up then attach your ball link bang on the 12mm line, as your retract servo travels through its full 180Deg turn it will push the rod exactly 24mm locating a positive up & down lock providing you set it up so its start and stop points are in a straight line with the retract unit.[/quote]